MÁY KIỂM TRA NHIỆT ĐỘ QUE HÀN HAKKO FG100B-83

Danh mục sản phẩm

Trang Chủ Sản Phẩm THIẾT BỊ ĐO PHÒNG SẠCH, MÔI TRƯỜNG MÁY KIỂM TRA NHIỆT ĐỘ QUE HÀN HAKKO FG100B-83

MÁY KIỂM TRA NHIỆT ĐỘ QUE HÀN HAKKO FG100B-83
Mã SP: FG100B-83
Giá: Liên Hệ
Automatic measurement to standardize the process. Minimize individual differences in how to complete measurement and read result.
Danh mục: THIẾT BỊ ĐO PHÒNG SẠCH, MÔI TRƯỜNG
Nhà sản xuất: HAKKO

HAKKO Japan

Thermometer / soldering tester

MODEL: FG100B-83

Key Features:

- Automatic measurement to standardize the process

- Automatic temperature measurement

- Measurement counter can be useful for control of changing sensor.

- Fine sensor can deliver accurate measurements.

HAKKO

*Automatic temperature measurement：AUTO HOLD Function

The measurement will end automatically when tip temperature is stabilized.

The measurement process will be the same no matter who does it.

* Constant display of measured max. temperature：MAX HOLD Function

Max measured tip temperature will be displayed.

This function can be useful for quality control of components and P.W.B.

Note: Equipment with Fake consumer electronics in China, or consider choosing the authentics goods.

Product number	FG100B-83	FG100B-84
Proofreading	none	With factory calibration
power supply	Dry cell 9V type (alkaline dry cell recommended)
Temperature resolution	1 ℃
Temperature measurement range	0-700 ℃
Temperature measurement tolerance	± 3 ° C (range of 300 to 600 ° C) ± 5 ° C (other temperature range)
Temperature sensor	K (CA) thermocouple
display	LCD display: 3 1/2 digits
Operating environment	Operating temperature / humidity range: 0-40 ° C, 80% RH maximum (no condensation)
Environmental condition	Applicable rated pollution degree 2 (according to IEC / UL 61010-1)
External dimensions	75 (W) x 44 (H) x 140 (D) mm
weight	125g

About the initial display (room temperature) that appears when the power is turned on

It is not necessary to subtract the room temperature displayed when the power is turned on from the measurement results.
The displayed value on the liquid crystal display is the measured value.

Guaranteed temperature range of measurement tolerance ± 3 ° C

Generally, the optimum temperature range for soldering is 300 ° C to 500 ° C, and the optimum temperature for SMD rework systems is 300 ° C to 600 ° C. The tolerance in the optimum temperature range (300 ° C to 600 ° C) is guaranteed to be ± 3 ° C.
Other temperature ranges are not guaranteed, but are within a tolerance of approximately ± 5 ° C.

External dimensions exclude protrusions.
Weight excludes batteries.
The temperature sensor can only be used for measurements up to 500 ° C. Use a temperature probe when measuring above 500 ° C.
If the temperature sensor is not installed or is cut off, the burnout display will be displayed. Also, if a value outside the measurement range is entered, the burnout display will be displayed.
Burnout display (minus display)
- "Calibration certificate, inspection report, traceability system diagram" is attached with the factory calibration.
  Please inform the store of the address of the documents at the time of purchase.